What is the Principle of Cathodic Protection for Steel in Buried or Immersed Concrete Structures?
What is the Principle of Cathodic Protection for Steel in Buried or Immersed Concrete Structures? Cathodic protection for steel in buried or immersed concrete follows the same basic principles as for atmospherically exposed concrete. The principle difference is that the concrete is likely to become water saturated, which will result in reduction in oxygen content at the steel surface under normal exposure conditions, which will be accelerated under the application of cathodic protection. Where oxygen depletion occurs, the potential
Principles of Cathodic Protection and Its Application to Steel in Concrete
Principles of Cathodic Protection and Its Application to Steel in Concrete Steel in concrete is usually protected against corrosion by passivation of the steel arising from the high alkalinity of the pore solutions within the concrete. A stable oxide layer is formed on the steel surface which prevents the anodic dissolution of iron. The necessity for additional protective measures arises if this stable oxide layer is rendered unstable (if depassivation occurs) due to the ingress of chlorides to the steel/concrete interface or carbo
The Notices on Electrical Installation for Cathodic Protection System
The Notices on Electrical Installation for Cathodic Protection System All electrical installation works shall be undertaken in accordance with international (or other applicable national) electrical safety standards. Below are some notices on electrical installation for cathodic protection system. Note 1: The electrical power supply for the cathodic protection system may be provided by transformerrectifier(s) powered by an electrical supply from a mains voltage distribution system. The direct current and monitoring cables of
How is the MMO Anode Installed in Cathodic Protection?
How is the MMO Anode Installed in Cathodic Protection? Before anode installation, the surface should be well prepared. The concrete surfaces intended to receive installation of anode material, e.g. conductive coatings or activated titanium mesh within a cementitious overlay, shall be prepared so as to present, as a minimum, a clean, non‑friable surface and in order that the substrate to overlay adhesion. Cathodic protection conductive coatings generally require a minimum of preparation to leave a maximum of cement paste and mini
Recommend Read
-
Japan Clients Visited UTron Factory
0n 20th November, Japan Clients visit UTron Technology Co.,Ltd factory for technical communication of ICCP titanium anodes of MMO tubular anode, MMO ribbon anode etc., they discussed the working environmen
-
Middle East Client Visited UTron Factory
The Middle East clients who have cooperated with UTron Technology Co.,Ltd for more than ten years visited UTron factory on 15th October. They highly praised the excellent quality of ICCP titanium anodes an
-
UTron Celebrated The 10th Anniversary
UTron Technology Co.,Ltd (previously named Elade) was founded on 8th September in Xi’an, China. It is one of the leading manufacturers of titanium electrode and titanium electrolyzer in China. It has expert technic
-
UTron Attended The CORROSION 2016 in Canada
CORROSION 2016 was held on 6-10 March 2016 in Vancouver, British Columbia, Canada. UTron Technology Co., Ltd( previously named Elade) attended this exhibition, they showed their latest technology of ICCP titanium anode,
-
UTron Visited The 4th China International Drinking Water Exhibition
The 4th China (Guangzhou) International High-end Drinking Water and Water Equipment Exhibition were held in 9th -11th September in Guangzhou China. It is mainly for hydrogen ionizer cup, hydrogen water generator, hydroge